Use of the physical reset button may result in a node 500 issue. This will be noticible based on the SSID being broadcast by your WiFiRanger device. Units with this issue will broadcast an SSID in the following format: PVT.WFR_Model.5000. Follow these steps to recover your device:

Recovery Process

1. Connect to the WiFiRanger:

   • Connect your computer or device to the WiFiRanger's network. The network name (SSID) will be:
     • Broadcast: Pvt.WFR_Model.5000
     • Password: changemenow5000

2. Open Web Browser:

   • Open a web browser (Chrome, Internet Explorer, Safari, Firefox, etc.).

3. Enter Address:

   • In the address bar, enter either:
     • http://mywifiranger.com
     • 10.150.0.1:8080

4. Wait for Control Panel:

   • Wait for the WiFiRanger Control Panel to load.

5. Connect to Internet:

   • Connect the WiFiRanger to an internet source (cellular, Wi-Fi WAN, etc.).

6. Check for Updates:

   • Click on "Check for Updates / Cloud Disconnected" at the top right of the Control Panel.

7. Wait:

   • Wait for 1-2 minutes for the update process to complete.

8. Check WiFi Networks:

   • On your computer or device, check the list of available WiFi networks.
   • Look for a network named "DONE-XXXXXX" (the Xs will be replaced with numbers). This indicates the recovery process is complete.

9. Reboot WiFiRanger:

   • Reboot the WiFiRanger.

10. Connect to Original Network:

    • Connect to the WiFiRanger using its original network name and password (found on the product label).

Important Note:

• Do not use the physical reset button on an indoor WiFiRanger router. This may cause a Node 500 issue.

If you continue to experience issues after following these steps, contact WiFiRanger support for further assistance.